Heating system installation and modernisation
Plant rooms, underfloor heating, radiators, manifolds and controls.
A heating system works as a whole
The heat source, pipework, manifolds, circulation pumps, radiators or underfloor heating circuits, and controls need to work together. Simply replacing a boiler or pump is not always enough: comfort and running costs may be affected by incorrect flow balancing, excessive temperature, awkward controls or poorly insulated pipework.
What work we assess
We accept enquiries for plant room installation and alterations, underfloor heating manifolds, radiators, circulation, hydraulic assemblies and controls. During renovation, we check whether the existing system suits the proposed heat source. If an air-to-water heat pump is being considered, the required water supply temperature and the building's heat demand need to be assessed, not just the total floor area.
Selection and quotation
Start with a short question and one contact method. If you know them, you can include the approximate heated area, the current heat source and the change you want. We can clarify insulation, heat emitters and hot-water needs later. Plans and other documents are not required in the initial form; we will discuss whether further information, a heat-loss calculation or a site visit is needed.
During installation
We coordinate assembly locations, service space, pipe routes, condensate or safety valve drainage and electrical requirements. On completion, system leak-tightness and operation are checked and the basic operating modes are set. It is worth adjusting control parameters gradually while observing room temperatures and the system's response.
Describe your property – we will suggest a suitable solution
Briefly describe what you need and choose one contact method for a reply. If photos or other technical information are needed later, we will agree how to provide them when we get in touch.